Change a Propane Tank
Propane powered forklifts are commonly used in warehouses. The lift truck is designed with the propane tank mounted at the back of the operator. The tanks, that look a lot like beer kegs, have to be replaced every so often since they have a limited lifespan. Forklift drivers must utilize care when handling propane tanks. Compressed gases are dangerous, particularly because the gas is flammable. Utilize care when replacing and removing propane tank to avoid injury.
1 If there is a need to change the propane tank, the first step is to stop the lift truck, then turn the tank valve off. The forklift should be left on until the engine dies. This process burns off the gas inside the transfer hose which connects the tank and the engine. Prior to taking the second steps, wear the correct safety equipment, like insulated gloves made of either leather or neoprene. It is vital for you to protect your skin from contact with the compressed gas, that is extremely cold.
2 The hose of the tank has to be disconnected, followed by removing the tank from its holding straps. When you put in a new tank, reattach the holding straps and reconnect the hose at the valve of the tank by tightening the nut.
3 You could check for leaks by applying soapy water to the valve and opening it slightly. Leaking gas will cause bubbles to foam around the value. If this happens, check the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks in the area of the valve, and afterward do the leak inspection process over again. Persistent leaks mean that both the connecting hose and nut would have to be replaced. However, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Open the valve all the way to enable the gas to fill the connecting hose. After that you can start the lift truck and resume operating.